LTEC minimal lubricating systems have been designed to replace traditional lubrication with oil emulsion or neat oil in machining with chip removal, molding and cold deformation. Uses lubricants from renewable bases that replace conventional fluids, eliminating registration requirement and disposal of exhausted liquid.
The micro-pneumatic pumps dose the minimum amount of lubricant that is transported by a flow of compressed air towards the tool/workpiece contact point without creating mist or pollution. The lubricant is consumed only during the processing phase.
It is possible to obtain an immediate increase in productivity because machine, working area and piece cleaning times are eliminated.
A further advantage in cost reduction is derived from the increase in tool life, which kept at room temperature significantly increases its life; and also eliminates any possible health problems deriving from contact with traditional fluids.

MODEL FOR BAND SAWS
The ECU consists of a 1.2-liter tank with electric level control, frequency generator, needle valve to regulate the flow of compressed air coming out of the nozzel, micro-pump single-acting pneumatic pump, solenoid valve to start and the stop of the control unit, nozzel for band sawing machine complete with 5 meters of coaxial pipe.